HQ EL-PIRLA30 Specifications download pdf (Page 3)

Function

• Auto identification of day and night, the light-control can be adjusted, so it works at night

automatically and stops in daytime.

• Time setting can be adjusted.

Installation

N - Neutral

L - Live

- Earth

(1) Please shut off the power before installation.

(See following diagram)

(2) Loosen the screw on the rear lid of the junction box.

(3) Connect the power to the sensor lamp according to connection diagram.

(4) Install the sensor lamp in the selected location according to installation diagram.

(5) Replace the rear lid and tighten the screw. Test the lamp.

Test

1) Sensitivity: Adjust knob “1” clockwise to raise its sensitivity and counter-clockwise to reduce its

sensitivity.

2) Adjust knob “2” clockwise to lengthen operating time and counter-clockwise to shorten it.

3) Light control: Adjust knob “3” to select different illumination levels. (See Fig.)

4) Switch on the power, the lamp will turn on within 5s and turn off within 5-30s: after it turning off and

detecting motion the lamp will turn on again. Without detecting any motion it will turn off after

5~10s.

5) Turn the light control to night, cover the detection window (simulating night), and move in front of

the lamp. It turns on and will switch off after 5~10s if no movement is detected.

ATTENTION: When using this product, please adjust the sensitivity to an appropriate level;

please do not adjust the sensitivity to maximum, to prevent the product from working normal.

Too high sensitivity may detect the wrong kind of motion, such as the wind blowing leaves or

curtains, small animals.

If the product does not work normal, please try to reduce the sensitivity and test again.

Note

Do not install in direct sunlight or air stream and quick temperature changes. Do not touch or impact

the lens and do not clean with aggressive agents.

1 2 3 4 5 6 7 8 ... 44 45

No comments

HQ EL-PIRLA30 Specifications Page 3